Steering Column Component Installation Note

CAUTION:

If the steering column is installed, install it according to the procedure to prevent damage to intermediate shaft that could result if the steering column is installed in the incorrect order.
Do not unlock the adjusting lever until after the steering column installation is completed to prevent damage to the steering column.

Temporarily install nut B to the dashboard member.
Tilt the steering column component towards the temporarily installed nut B and temporarily install the steering column component to the instrument panel member using nut A

Fig 1: Identifying Loosen Nut B
Tighten the nuts in the order of nut A and nut B.

Fig 2: Steering Gear (Pinion Shaft) Nut With Torque Specifications
Insert the intermediate shaft into the steering gear (pinion shaft) to the position shown in the figure, and tighten it using a new bolt.

Fig 3: Steering Gear Joint Bolt With Torque Specifications