FixVault
Home › Mazda › 2014 › 3 SV, Automatic Trans › Repair and Diagnosis › Body & Frame › Ignition Switch/Steering Lock › Power Systems › Front Wiring Harness Protector Removal/Installation › Front Wiring Harness Protector No. 2

Front Wiring Harness Protector No. 2

  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
  2. Remove the battery tray. (See BATTERY REMOVAL/INSTALLATION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
  3. While pressing the clip tabs of front wiring harness protector No. 2 in the direction of the arrows (1) shown in the figure, pull the clip of front wiring harness protector No. 2 in the direction of the arrow (2) shown in the figure to detach the clip tabs of front wiring harness protector No. 2 from the engine mount.
    Fig 1: Pressing Front Wiring Harness Protector No. 2
    G09784346Courtesy of MAZDA MOTORS CORP.
  4. Pull out the clip.
  5. Lift up the cap of front wiring harness protector No. 2 in the direction of the arrow shown in the figure.
    Fig 2: Lifting Up Cap Of Front Wiring Harness Protector No. 2
    G09784347Courtesy of MAZDA MOTORS CORP.
  6. Pull out the front wiring harness protector No. 2 from the stud bolt and set it aside as shown in the figure.
    Fig 3: Pulling Out Front Wiring Harness Protector No. 2 From Stud Bolt
    G09784348Courtesy of MAZDA MOTORS CORP.
  7. While pressing the clip tabs in the direction of the arrows (3) shown in the figure, push out the clip in the direction of the arrow (4) shown in the figure to detach the clip tabs from the front wiring harness protector No. 2.
    Fig 4: Pressing Clip Tabs
    G09784349Courtesy of MAZDA MOTORS CORP.
  8. Pull out the clip.
  9. Insert the remover tool into the front wiring harness protector No. 2 tabs in the positions shown in the figure.
    Fig 5: Inserting Remover Tool Into Front Wiring Harness Protector No. 2 Tabs
    G09784350Courtesy of MAZDA MOTORS CORP.
  10. While lifting up the hook in the direction of the arrow (5) shown in the figure using a remover tool, pull the hook in the direction of the arrows (6) shown in the figure to detach the tab from the hook.
    Fig 6: Lifting Up Hook
    G09784351Courtesy of MAZDA MOTORS CORP.
  11. Detach all the tabs from hooks and remove the front wiring harness protector No. 2.
  12. Install in the reverse order of removal.
About FixVault