Condenser Removal/Installation
WARNING: This page is about a different car, the 2014 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.5] .)
- Remove the following parts:
- Rear scuff plate (LH) (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
- Rear seat cushion (LH) (See REAR SEAT CUSHION REMOVAL/INSTALLATION .)
- Rear side seat back (LH) (See REAR SEAT BACK REMOVAL/INSTALLATION .)
- Tire house trim (LH) (See TIRE HOUSE TRIM REMOVAL/INSTALLATION .)
- C-pillar trim (LH) (See C-PILLAR TRIM REMOVAL/INSTALLATION .)
- Disconnect the connector.
- Remove the bolt.
- Remove the condenser.
- Install in the reverse order of removal.