FixVault
Home › Mazda › 2014 › 3 SV, Automatic Trans › Repair and Diagnosis › External Pages › Different car › Section 80 (Symptom Troubleshooting - Security And Lock System) › Push Button Start System Does Not Operate › Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2014 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
PUSH BUTTON START SYSTEM DOES NOT OPERATE (SECURITY AND LOCKS) DIAGNOSTIC PROCEDURE

Step Inspection Action
1 INSPECT IF MALFUNCTION CAUSE IS OPEN CIRCUIT IN WIRING HARNESS BETWEEN START STOP UNIT AND PUSH BUTTON START 
  • Disconnect the negative battery cable.

    (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.5] .)

  • Disconnect the start stop unit and push button start connector.
  • Inspect for continuity between the following terminals (vehicle wiring harness).
    • Start stop unit terminal 1H and push button start terminal C
    • Start stop unit terminal 2J and push button start terminal I
  • Is there continuity?
 Yes Go to the next step.
No
  • Repair or replace the wiring harness for an open circuit.
  • After repair procedure, go to Step 3.
2 INSPECT IF MALFUNCTION CAUSE IS OPEN CIRCUIT IN WIRING HARNESS BETWEEN START STOP UNIT AND GROUND 
  • Verify that the start stop unit connector is disconnected.
  • Inspect for continuity between the following terminals (vehicle wiring harness).
    • Start stop unit terminal 1 AF and ground
    • Start stop unit terminal 2B and ground
  • Is there continuity?
 Yes Go to the next step.
No
  • Repair or replace the wiring harness for an open circuit.
  • After repair, go to the next step.
3 VERIFY IF MALFUNCTION CAUSE WAS CORRECTED 
  • Does the push button start button operate correctly?
 Yes Troubleshooting completed. (Explain the contents of the servicing to the customer.)
No If the malfunction has not been resolved, repeat the inspection from Step 1.
About FixVault