Section 37 (Security System And Lock System)
WARNING: This page is about a different car, the 2013 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
- Security And Locks Location Index
- Front Outer Handle Removal/Installation
- Rear Outer Handle Removal/Installation
- Inner Handle Removal/Installation
- Door Lock Switch Removal/Installation
- Door Lock Switch Inspection
- Hood Latch And Release Lever Removal/Installation
- Hood Release Cable Removal/Installation
- Hood Latch Switch Inspection
- Fuel-Filler Lid Opener And Lever Removal/Installation
- Fuel-Filler Lid Opener Cable Removal/Installation
- Front Door Key Cylinder Removal/Installation
- Front Door Key Cylinder Switch Inspection
- Front Door Latch And Lock Actuator Removal/Installation
- Front Door Latch And Lock Actuator Inspection
- Front Door Lock Actuator Inspection
- Front Door Latch Switch Inspection
- Door Lock-Link Switch Inspection
- Door Lock Striker Removal/Installation
- Rear Door Latch And Lock Actuator Removal/Installation
- Rear Door Latch And Lock Actuator Inspection
- Rear Door Lock Actuator Inspection
- Rear Door Latch Switch Inspection
- Door Lock System Operation Record
- Liftgate Latch And Lock Actuator Removal/Installation
- Liftgate Latch And Lock Actuator Inspection
- Liftgate Lock Actuator Inspection
- Liftgate Latch Switch Inspection
- Liftgate Lock Striker Removal/Installation
- Liftgate Opener Switch Removal/Installation
- Liftgate Opener Switch Inspection
- Start Stop Unit Removal/Installation
- Start Stop Unit Inspection
- Start Stop Unit Configuration (Using Read/Write Function)
- Start Stop Unit Configuration (Using As-Built Data)
- LF Control Unit Removal/Installation
- LF Control Unit Inspection
- Security And Locks Personalization Features Setting Procedure
- Request Switch Removal/Installation
- Request Switch Inspection
- Keyless Antenna Removal/Installation
- Keyless Beeper Removal/Installation
- Keyless Beeper Inspection
- Keyless Receiver Removal/Installation
- Keyless Receiver Inspection
- Remote Transmitter Disassembly/Assembly
- Remote Transmitter Id Code Registration
- Clearing Remote Transmitter
- Remote Transmitter Battery Voltage Inspection
- Immobilizer System-Related Parts Programming
- Foreword
- Selection of Procedure for Immobilizer System-Related Parts Programming
- M-MDS Connecting Procedure
- Procedure for Communication Between Coil Antenna and Remote Transmitter
- No.1 Additional Remote Transmitter Programming Procedure (Using the M-MDS)
- No.2 Programming Procedure After PCM Replacement
- No.3 Start Stop Unit Replacement and Programming Procedure Due to Simultaneous Replacement of Start Stop Unit/PCM
- No.4 Remote Transmitter Replacement or Remote Transmitter Clearing
- Theft-Deterrent Horn Removal/Installation
- Theft-Deterrent Horn Inspection
- Theft-Deterrent System Operation Record