When Not Using the M-MDS
WARNING: This page is about a different car, the 2013 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
- Empty the vehicle by having all occupants leave the vehicle and remove all the cargo except for the spare tire, jack and tools equipped on the vehicle.
- Adjust the air pressure of each tire to the specified value. (See WHEEL AND TIRE SPECIFICATION ).
- Switch the ignition ON (engine off or on).NOTE:
- The AFS OFF indicator light continues flashing during the first initial setting, however, continue the work because it does not indicate an improper procedure.
- Using a jumper wire, connect DLC-2 terminals B and J (ground) three times at 0.5 to 1.5 s
intervals as shown in the figure.
CAUTION:
- If the terminals are mistakenly connected, vehicle damage or fire could occur. When connecting with the jumper wire, thoroughly verify what terminals are being connected to prevent a miss-connection.
- Verify the AFS OFF indicator light.
- If the AFS OFF indicator light flashes three times at 0.25 s intervals and turns off as shown in the figure, the initial setting is completed. Go to the next step.
- If the AFS OFF indicator light continues flashing, the procedure may be performed incorrectly. Repeat the procedure from Step 1.
- If the AFS OFF indicator light is illuminated, the headlight auto leveling system may have a malfunction. Perform the DTC inspection. (See
DTC INSPECTION [ADAPTIVE FRONT LIGHTING SYSTEM (AFS)]
).
- Repair or replace the malfunctioning area, then repeat the procedure from Step 1.
- Adjust the headlight aiming. (See HEADLIGHT AIMING ).