Teflon Seal Installation Note

WARNING: This page is about a different car, the 2014 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

49 D013 102, 49 D013 103, and 49 D013 104 are component parts for 49 D013 1A0.

Apply engine oil to the SST .

Fig 1: Applying Engine Oil To SST
Courtesy of MAZDA MOTORS CORP.
Install the SST with the mark on the SST facing the fuel injector.

Fig 2: Installing SST With Mark On SST Facing Fuel Injector
Courtesy of MAZDA MOTORS CORP.
Insert a new teflon seal onto the SST .

Fig 3: Inserting Teflon Seal Onto SST
Courtesy of MAZDA MOTORS CORP.
Install the SST equipped with the teflon seal to the end of the fuel injector.

Fig 4: Installing SST Equipped With Teflon Seal To Fuel Injector
Courtesy of MAZDA MOTORS CORP.
Using the SST , press on the teflon seal to the fuel injector side.

Fig 5: Pressing On Teflon Seal To Fuel Injector Side
Courtesy of MAZDA MOTORS CORP.
Press on the teflon seal to the position indicated in the figure, then remove the SST .

Fig 6: Pressing On Teflon Seal
Courtesy of MAZDA MOTORS CORP.
Install the teflon seal to the fuel injector by hand and remove the SST .

Fig 7: Installing Teflon Seal To Fuel Injector
Courtesy of MAZDA MOTORS CORP.
Slide the SST to the end of the fuel injector.

Fig 8: Slide SST To Fuel Injector End
Courtesy of MAZDA MOTORS CORP.
Hold the SST at the position shown in the figure and correctly position the teflon seal for more than 30 sec.

Fig 9: Holding SST At Position
Courtesy of MAZDA MOTORS CORP.