LED Illumination Inspection

1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
2. Remove the lower decoration panel. (See DECORATION PANEL REMOVAL/INSTALLATION .)
3. Remove the push button start. (See PUSH BUTTON START REMOVAL/INSTALLATION .)
4. Apply battery positive voltage and connect the ground to the push button start terminals and verify that the LED illuminates as indicated in the table.

Fig 1: Applying Battery Positive Voltage To Push Button Start

Courtesy of MAZDA MOTORS CORP.

Fig 2: Push Button Start Terminal Chart

Courtesy of MAZDA MOTORS CORP.

• If the LED does not illuminate as indicated in the table, replace the push button start. (See PUSH BUTTON START REMOVAL/INSTALLATION .)