FixVault
Home › Mazda › 2018 › 6 Signature › Repair and Diagnosis › External Pages › Different variant/trim › Section 2 (Manual Transaxle - Overhaul [C66M-R]) › Primary Shaft Component Assembly › Synchronizer Ring Assembly Note

Synchronizer Ring Assembly Note

WARNING: This page is about a different variant/trim than selected.
  1. Align the projection of the synchronizer ring with the key groove of the clutch hub as shown in the figure, and assemble the synchronizer ring.
    Fig 1: Aligning Projection Of Synchronizer Ring With Key Groove Of Clutch Hub
    G08347863
About FixVault