LED Illumination Inspection

Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
Remove the lower decoration panel. (See DECORATION PANEL REMOVAL/INSTALLATION .)
Remove the push button start. (See PUSH BUTTON START REMOVAL/INSTALLATION .)
Apply battery positive voltage and connect the ground to the push button start terminals and verify that the LED illuminates as indicated in the table.

Fig 1: Applying Battery Positive Voltage To Push Button Start Terminals
Courtesy of MAZDA MOTORS CORP.

Fig 2: Push Button Start Terminals Continuity Chart
Courtesy of MAZDA MOTORS CORP.
- If the LED does not illuminate as indicated in the table, replace the push button start. (See PUSH BUTTON START REMOVAL/INSTALLATION .)