FixVault

PID/DATA monitor item table

PID/DATA MONITOR DESCRIPTION

Item (definition) Unit/Condition Definition
A_SCR_C_TMP °C, °F Average SCR catalyst temperature
C_T_B1S2 °C, °F Exhaust gas temperature sensor No. 2
CL_NMHC_MN_CP - Catalyst monitoring completed/NMHC catalyst monitoring completed
CMP_MNT_ENA - Comprehensive component monitoring enabled
COMP3_MNT - Comprehensive component monitoring completed
CONF_URA_TK_LV - Configuration for urea tank level
CP_IGN_SP - Compression ignition monitoring supported
CTLY_NMHC_MN - Catalyst monitoring/NMHC catalyst monitoring
CTRL_MOD_VOL V Control module voltage
DC_PWM_O_PS_UV % Duty cycle of the PWM signal output to the power stage of urea dosing valve
DIS_ACT_MIL km, ft, mi Distance traveled while check engine light is activated
DIS_CLR_DTC km, ft, mi Distance Since DTCs cleared
DPES_DS_NOX - Dew point end signal for downstream NOx sensor
DPES_PM - Dew point end signal for PM sensor
DPES_US_NOX - Dew point end signal for upstream NOx sensor
DSR_D_AMO - (mg/s) Desired dosing amount
EG_MF - (kg/h) Exhaust gas mass flow
EGR_VVT_MCC - (Undefined/Not Used) EGR and/or VVT monitor completion condition counts
EGR_VVT_MCEC - (Undefined/Not Used) EGR and/or VVT monitor conditions encountered counts
EGR_VVT_MN_CP - EGR and/or VVT system monitoring completed
EGR_VVT_MNT - EGR and/or VVT system monitoring
EGS_MCC - (Undefined/Not Used) Gas sensor monitor completion counts
EGS_MCEC - (Undefined/Not Used) Exhaust gas sensor monitor conditions encountered counts
EIAECD1_TT_SUP - Total run time with EI-AECD #1 active supported
EIAECD1_TT_TM1 hh:mm:ss Total run time with EI-AECD #1 Timer 1 active
EIAECD1_TT_TM2 hh:mm:ss Total run time with EI-AECD #1 Timer 2 active
EIAECD2_TT_SUP - Total run time with EI-AECD #2 active supported
EIAECD2_TT_TM1 hh:mm:ss Total run time with EI-AECD #2 Timer 1 active
EIAECD2_TT_TM2 hh:mm:ss Total run time with EI-AECD #2 Timer 2 active
EIAECD3_TT_SUP - Total run time with EI-AECD #3 active supported
EIAECD3_TT_TM1 hh:mm:ss Total run time with EI-AECD #3 Timer 1 active
EIAECD3_TT_TM2 hh:mm:ss Total run time with EI-AECD #3 Timer 2 active
EIAECD4_TT_SUP - Total run time with EI-AECD #4 active supported
EIAECD4_TT_TM1 hh:mm:ss Total run time with EI-AECD #4 Timer 1 active
EIAECD4_TT_TM2 hh:mm:ss Total run time with EI-AECD #4 Timer 2 active
EIAECD5_TT_SUP - Total run time with EI-AECD #5 active supported
EIAECD5_TT_TM1 hh:mm:ss Total run time with EI-AECD #5 Timer 1 active
EIAECD5_TT_TM2 hh:mm:ss Total run time with EI-AECD #5 Timer 2 active
EVAP_SYS_MN - Evaporative system monitoring
EVAP_SYS_MN_CP - Evaporative system monitoring completed
FU_SYS_CP - Fuel system monitoring completed
FU_SYS_ENA - Fuel system monitoring enabled
FUEL_MCC - (Undefined/Not Used) Fuel monitor completion condition counts
FUEL_MCEC - (Undefined/Not Used) Fuel monitor conditions encountered counts
HT_NOX_SRC_MN - Heated catalyst monitoring/NOx/SCR after treatment monitoring
HTR_TANK Off/On Urea tank heater
IGN_CYCL_CNT - (Undefined/Not Used) Ignition cycle counter
INTG_D_MFB - (g) Integrated dosing mass feedback
IP_C_HT_HCU - (mA) Input current of heater from HCU
LLMD_SIG2_DNOX - Linear lambda signal of 2. downstream Nox sensor from CAN
MSF_CP - Misfire monitoring completed
MSF_ENA - Misfire monitoring enabled
NMHC_C_MCC - (Undefined/Not Used) NMHC catalyst monitor completion counts
NMHC_C_MCEC - (Undefined/Not Used) NMHC catalyst monitor conditions encountered counts
NO_DTM_CCT - (ppm) The determined NOx concentration
NOX_ADS_MCC - (Undefined/Not Used) NOx adsorber monitor completion condition counts
NOX_ADS_MCEC - (Undefined/Not Used) NOx adsorber monitor conditions encountered counts
NOX_C_B1S1 - (ppm) The exhaust gas NOx concentration before SCR converter
NOX_C_B1S1_SUP - The exhaust gas NOx concentration by NOx sensor No. 1 supported
NOX_C_B1S2 - (ppm) The exhaust gas NOx concentration after SCR converter
NOX_C_B1S2_SUP - The exhaust gas NOx concentration by NOx sensor No. 2 supported
NOX_C_B2S1 - (ppm) The exhaust gas NOx concentration before SCR converter
NOX_C_B2S1_SUP - The exhaust gas NOx concentration by NOx sensor No. 1 supported
NOX_C_B2S2 - (ppm) The exhaust gas NOx concentration after SCR converter
NOX_C_B2S2_SUP - The exhaust gas NOx concentration by NOx sensor No. 2 supported
NOX_CCT_ATO1 - (ppm) NOx Concentration from ATO1
NOX_SCR_C_MCC - (Undefined/Not Used) NOx/SCR Catalyst Monitor Completion condition counts
NOX_SCR_C_MCEC - (Undefined/Not Used) NOx/SCR Catalyst Monitor Conditions encountered counts
NOX_SIG_ATO1 - NOx signal status from ATO1
NOX_SRC_MN_CP - Heated catalyst monitoring completed/NOx/SCR after treatment monitoring completed
NOX_ST_SEN_SIG - Status of NOx sensor signal
O2_CCT_ATO1 - Oxygen Concentration from ATO1
O2_SH_PM_F - Oxygen sensor heater monitoring/PM filter monitoring
O2_SH_PM_F_CP - Oxygen sensor heater monitoring completed/PM filter monitoring completed
O2_SIG_ST_ATO1 - Oxygen signal status from ATO1
O2_SM_EGSM - Oxygen sensor monitoring/exhaust gas sensor monitoring
O2_SM_EGSM_CP - Oxygen sensor monitoring completed/exhaust gas sensor monitoring completed
OBD_MCEC - (Undefined/Not Used) OBD Monitoring conditions encountered counts
OP_ADC - (mA) OP of the ADC
OP_F_ACT_PS - (Hz) Output frequency for activation of the power stage
OP_S_FL_H_MM - (mm, in) Output signal of the fill level height in mm
PMF_MCC PM - (Undefined/Not Used) Filter monitor completion condition counts
PMF_MCEC - (Undefined/Not Used) PM filter monitor conditions encountered counts
PMS_A_B1S1 - PM sensor active status bank 1 sensor 1
PMS_NO_B1S1 - (%) The PM sensor output value
PMS_O_B1S1_SUP - PM sensor operating status bank 1 sensor 1 supported
PMS_O_B2S1_SUP - PM sensor operating status bank 2 sensor 1 supported
PMS_R_B1S1 - PM sensor regen status bank 1 sensor 1
PMS_S_B1S1_SUP - PM sensor signal bank 1 sensor 1 supported
PMS_S_B2S1_SUP - PM sensor signal bank 2 sensor 1 supported
RDC_PMP_DC_CM - Reductant pump duty cycle - commanded
RDCT_INJ_DUCY % Reductant injector duty cycle
RDCT_LINE_HEAT - Reductant line heater
RDCT_RVDC_CMD % Reductant reverting valve duty cycle - commanded
RDCT_TANK_HEAT - Reductant tank heater
RE_TANK_LV % Reagent tank level
RE_TANK_LV_SUP - Reagent tank level supported
REDUCT_INJ_DC % Reductant injector duty cycle
REV_VALVE Off/On Urea reverting valve
RLA_UR_PMP_PRE - (hPa) DEF pump module pressure
RMN_DF_TM_PR_L -(s) Remaining defrosting time of the pressure line
RMN_DF_TM_TK -(s) Remaining defrosting time of the tank
RMN_ML_DIRC - (km mile) Remaining mileage directly based on reducing agent in tank
RMN_TM_SP_DF -(s) Remaining time for supply module defrost
RRDC_AG_RMN - (%) Remaining quantity of reducing agent
S_LLMD_V2_DNOX - State of lin lambda value of 2.downstream NOx sensor
S_STT_HYD_SCR - Sub state of hydraulic SCR-system
S_UR_TANK_TMP °C, °F Sensed urea tank temperature
SDARS_BSPR_CP - Secondary air system monitoring completed/boost pressure system monitoring completed
SDARS_BSTPRE - Secondary air system monitoring/boost pressure system monitoring
SPDC_URDC % Set-point duty cycle from urea dosing controller
ST_DF_CHK - State of the defrosting check
ST_OP_S_PRE_HT - Status of output stage pressure heater
ST_OP_S_TK_HT - Status of output stage tank heater
STT_HYD_SCR - State of hydraulic SCR-system
VOLRDC_AG_RMN - (l) Remaining quantity of reducing agent [l]