| 1 |
Switch the ignition ON (engine off). |
- |
| 2 |
Wait for 40 s or more. |
- |
| 3 |
Continue to perform the configuration. |
- |
| 4 |
Perform the PCM data reset procedure. |
(See PCM DATA RESET .) |
| 5 |
Perform A/F sensor data reset procedure. |
(See AIR FUEL RATIO (A/F) SENSOR DATA RESET .) |
| 6 |
Switch the ignition off. |
- |
| 7 |
Perform the immobilizer system-related part programming. |
(See IMMOBILIZER SYSTEM-RELATED PARTS PROGRAMMING
.) |
| 8 |
Switch the ignition off. |
- |
| 9 |
Clear the DTCs. |
(See CLEARING DTC
.) |
| 10 |
Switch the ignition off. |
- |
| 11 |
Wait for 20 s or more. |
- |
| 12 |
Switch the ignition ON (engine off). |
- |
| 13 |
Perform the KOEO self test. |
(See KOEO/KOER SELF TEST
.) |
| 14 |
Switch the ignition ON (engine on). |
- |
| 15 |
Perform the KOER self test. |
(See KOEO/KOER SELF TEST
.) |
| 16 |
Switch the ignition off. |
- |
| 17 |
Perform compulsory diesel particulate filter regeneration. |
(See COMPULSORY DIESEL PARTICULATE FILTER REGENERATION .) |
| 18 |
Switch the ignition off. |
- |
| 19 |
Perform the following procedure:
- Warm up the engine until the engine coolant temperature is 70°C {158°F} or more.
- Switch the ignition off.
- Store "Complete (delete record)" the M-MDS session.
- Remove the M-MDS.
- Start the engine.
- Leave for 3 min while idling.
- Continuously drive the vehicle for 30 s at a vehicle speed of 50 km/h {31 mph} or more.
- When the warning light turns on or flashes, repeat the procedure from Procedure 5 (start the engine).
- After stopping the vehicle, leave it idling for 3 min without stopping the engine.
- Shift the selector lever to the D position with the brake pedal depressed and hold the vehicle stopped for 1 min.
- Continuously drive the vehicle for 30 s at a vehicle speed of 50 km/h {31 mph} or more again.
- When the warning light turns on or flashes, repeat the procedure from Procedure 5 (start the engine).
- Shift the selector lever to the D position with the brake pedal depressed and hold the vehicle stopped for 1 min.
|
- |
| 20 |
Clear the DTCs. |
(See CLEARING DTC
.) |
| 21 |
Switch the ignition off. |
- |