FixVault
Home › Mazda › 2019 › CX-9 Signature › Repair and Diagnosis › Body & Frame › Seats › Seats › Third-Row Seat Back Trim Removal/Installation › Notes

Third-Row Seat Back Trim Removal/Installation: Notes

CAUTION:
  • Be careful not to damage the ring C when removing/installing it. If a damaged ring C is used, it could result in improper installation of the third-row seat back board.
  • If the ring C is damaged, replace the ring C with a new one.
  1. Remove the third-row seat cushion. (See THIRD-ROW SEAT CUSHION REMOVAL/INSTALLATION .)
  2. Move hooks A in the direction of the arrow shown in the figure and detach them from hooks B.
    G11432604Courtesy of MAZDA MOTORS CORP.
  3. Unzip the zippers.
  4. While pressing the top tether anchor cover tabs in the direction of arrows (1) shown in the figure, move the top tether anchor cover in the direction of arrow (2) and remove it.
    G11432605Courtesy of MAZDA MOTORS CORP.
  5. Remove the cover and then remove the screw.
    G11432606Courtesy of MAZDA MOTORS CORP.
  6. Remove the C-rings.
    G11432607Courtesy of MAZDA MOTORS CORP.
  7. Remove the third-row seat back board.
  8. Remove the C-rings.
    G11432608Courtesy of MAZDA MOTORS CORP.
  9. Lift up the third-row seat back trim and third-row seat back pad as a single unit and remove it from the third-row seat back frame.
    G11432609Courtesy of MAZDA MOTORS CORP.
  10. Remove the C-rings shown in the figure, and remove the third-row seat back trim from the third-row seat back pad.
    G11432610Courtesy of MAZDA MOTORS CORP.
  11. Install in the reverse order of removal. (See THIRD-ROW SEAT BACK TRIM INSTALLATION NOTE .)
About FixVault