FixVault
Home › Mazda › 2020 › 6 Signature › Repair and Diagnosis › Body & Frame › Exterior/Interior Trim › Interior Trim › Rear Console Removal/Installation

Rear Console Removal/Installation

  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Remove the following parts:
    1. Side wall (See SIDE WALL REMOVAL/INSTALLATION .)
    2. Selector lever knob (ATX) (See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION .)
    3. Shift lever knob (MTX)
    4. Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION .)
    5. Front console box (See FRONT CONSOLE BOX REMOVAL/INSTALLATION .)
  3. Move the console panel in the order of arrows (1), (2) shown in the figure below, and remove it while detaching the hooks, clips.
    Fig 1: Moving Console Panel
    G12236373Courtesy of MAZDA MOTORS CORP.
  4. Disconnect the connectors.
    Fig 2: Wiring Harness Clip And Connectors
    G12236477Courtesy of MAZDA MOTORS CORP.
  5. Remove the wiring harness clip.
  6. Remove the cushion tape.
    Fig 3: Rear Console Component, Cushion Tape And Sheet Cushion
    G12236374Courtesy of MAZDA MOTORS CORP.
  7. Remove the sheet cushion.
  8. Remove the screws.
    Fig 4: Rear Console Component And Screws
    G12236375Courtesy of MAZDA MOTORS CORP.
  9. Remove the fasteners.
    Fig 5: Rear Console Component And Fasteners
    G12236376Courtesy of MAZDA MOTORS CORP.
  10. Move the rear console component in the direction of the arrow shown in the figure below, detach the clips from the center lower panel, and remove the rear console component.
    Fig 6: Moving Rear Console Component
    G12236481Courtesy of MAZDA MOTORS CORP.
  11. Install in the reverse order of removal.
    NOTE:
About FixVault