Total Toe-in Adjustment
WARNING: This page is about a different car, the 2020 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
- Loosen the locknut of the tie-rod end.
- Remove the boot clamp.
- Adjust the total toe-in by rotating each tie rod (left and right) in the opposite directions by the same amount respectively.
Specification
1.6±2 mm {0.063±0.08 in} (0°09'±10')
NOTE:- Toe angle changes by approx. 7 mm {0.3 in} in per one rotation of the tie rod for one wheel.
- Each tie rod has a right-hand thread.
- Tighten the locknut of the tie-rod end.
Tightening torque
69-98 N.m {7.1-9.9 kgf.m, 51-72 ft.lbf}
- Verify that the boot does not have any twisting and install the boot clamp.