PID/DATA Monitor Inspection
WARNING: This page is about a different car, the 2016 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- The BARO sensor is built into the PCM. When replacing the BARO sensor, replace the PCM.
- Connect the M-MDS to the DLC-2.
- Switch the ignition ON (engine off).
- Verify that the BARO sensor output value (PID: BARO) is within the specification. (See ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-G 2.0)]
.) (See PCM INSPECTION .)
- If not as specified, replace the PCM. (See PCM REMOVAL/INSTALLATION .)