FixVault
Home › Mazda › 2021 › 3 Base › Repair and Diagnosis (Single Page) › Engine Performance › System › On-Board Diagnostic - Engine Control System (VINS 7, L, M) (4 Of 4) › DTC U1032-00: Vehicle Control Module (VCM) Error › Function Inspection Using M-MDS

Function Inspection Using M-MDS

DIAGNOSTIC PROCEDURE - FUNCTION INSPECTION USING M-MDS

Step Inspection Results Action
1 PURPOSE: VERIFY RELATED REPAIR INFORMATION OR SERVICE INFORMATION AVAILABILITY
  • Verify related Service Bulletins, on-line repair information, or Service Information availability.
  • Is any related Information available?
 Yes Perform repair or diagnosis according to the available information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
2 PURPOSE: RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION
  • Record the freeze frame data/snapshot data.
NOTE:
  • Recording can be facilitated using the screen capture function of the PC.
 - Go to the next step.
3 PURPOSE: INSPECT FOR OTHER RELATED DTCs
  • Perform the DTC inspection for the PCM. (See DTC INSPECTION .)
  • Are any other DTCs displayed?
 Yes Repair the malfunctioning location according to the applicable DTC troubleshooting.
(See DTC TABLE [PCM (VINs 7, L, M (US)] .)
Go to the next step.
No Go to the next step.
4 PURPOSE: VERIFY VEHICLE CONTROL MODULE (VCM) DTC
  • Perform the DTC inspection for the vehicle control module (VCM). (See DTC INSPECTION .)
  • Are any DTCs displayed?
 Yes Repair the malfunctioning location according to the applicable DTC troubleshooting.
(See DTC TABLE [VEHICLE CONTROL MODULE (US)] .)
Go to Troubleshooting Diagnostic Procedure to perform the procedure from Step 1.
No Go to Troubleshooting Diagnostic Procedure to perform the procedure from Step 1.
About FixVault