DTC U0131-00: Communication Error To EPS Control Module: Outline

WARNING: This page is about a different variant/trim than selected.

DTC U0131:00 (TCM, GW6AX-EL, US) DETECTION CONDITION AND POSSIBLE CAUSE

System malfunction location	Communication error to EPS control module
Detection condition	Under the following condition, the TCM cannot receive the signal from EPS control module: Battery voltage is 10 V or more.
Fail-safe	Inhibits learning control. Inhibits neutral idle control.
Possible cause	CAN communication line malfunction between TCM and EPS control module TCM malfunction
System wiring diagram	Not applicable
Connector diagram	Not applicable