FixVault
Home › Mazda › 2021 › 3 Base › Repair and Diagnosis › External Pages › Different variant/trim › Section 19 (Engine Lubrication System (VIN M)) › Oil Pump Removal/Installation › Oil Pump Installation Note

Oil Pump Installation Note

WARNING: This page is about a different variant/trim than selected.
  1. Install the oil pump using the following procedure:
    1. Temporarily tighten the three bolts shown in the figure.
      G11436495Courtesy of MAZDA MOTORS CORP.
    2. Tighten the two bolts shown in the figure to the specified torque.
      G11436496Courtesy of MAZDA MOTORS CORP.
      NOTE:
      • The tightening order for the two bolts is optional.
    3. Finally, tighten the bolt shown in the figure to the specified torque.
G11436497Courtesy of MAZDA MOTORS CORP.
About FixVault