Selection of Procedure for Immobilizer System-Related Parts Programming

Verify that the ROOM fuse, AT fuse, and SRS2/ESCL fuse are installed.

Select the applicable programming procedure from the service content of the immobilizer system- related parts.

Immobilizer System-Related Parts Service and Programming Procedure Table

IMMOBILIZER SYSTEM-RELATED PARTS SERVICE AND PROGRAMMING PROCEDURE

No.	Service Programming procedure
1	Additional remote transmitter programming	Have remote transmitter that can start engine	(See NO. 1 ADDITIONAL REMOTE TRANSMITTER PROGRAMMING PROCEDURE (USING THE M-MDS) .)
2	Programming due to PCM replacement		(See NO. 2 PROGRAMMING PROCEDURE AFTER PCM REPLACEMENT .)
3	Start stop unit replacement and programming due to simultaneous replacement of start stop unit/PCM		(See NO. 3 START STOP UNIT REPLACEMENT AND PROGRAMMING PROCEDURE DUE TO SIMULTANEOUS REPLACEMENT OF START STOP UNIT/PCM .)
4	Remote transmitter replacement or clearing		(See NO. 4 REMOTE TRANSMITTER REPLACEMENT OR REMOTE TRANSMITTER CLEARING .)
5	Additional remote transmitter programming	There is no remote transmitter available that can start engine	(See NO. 5 ADDITIONAL REMOTE TRANSMITTER PROGRAMMING PROCEDURE (IF THERE IS NO REMOTE TRANSMITTER AVAILABLE THAT CAN START ENGINE) (USING M-MDS) .)

If servicing is performed after turning off (disabling) the pacemaker radio wave interference prevention function and the power saving function of the remote transmitter, turn on (enable) the functions.