Active Driving Display Inspection: Inspection

WARNING: This page is about a different car, the 2016 Mazda CX-3. However, it is still accessible from the selected car via links, so may be relevant.

Connect the M-MDS to the DLC-2.
After vehicle identification, select the following from the M-MDS initialization screen.
- "Data logger"
- "Module"
- "IC"
Using the simulation function LCD_SEG, verify that the display screen and open/close angle for the combiner change by pressing the tripmeter switch.

Number of times tripmeter switch is pressed

Display screen

Combiner open/close angle

-

G10915319

Courtesy of MAZDA MOTORS CORP.

G10915320

Courtesy of MAZDA MOTORS CORP.

1 time

G10915321

Courtesy of MAZDA MOTORS CORP.

G10915322

Courtesy of MAZDA MOTORS CORP.

2 times

G10915323

Courtesy of MAZDA MOTORS CORP.

G10915324

Courtesy of MAZDA MOTORS CORP.

3 times

G10915325

Courtesy of MAZDA MOTORS CORP.

G10915326

Courtesy of MAZDA MOTORS CORP.

4 times

G10915327

Courtesy of MAZDA MOTORS CORP.

G10915328

Courtesy of MAZDA MOTORS CORP.

5 times

G10915329

Courtesy of MAZDA MOTORS CORP.

G10915330

Courtesy of MAZDA MOTORS CORP.

6 times⁽¹⁾

G10915331

Courtesy of MAZDA MOTORS CORP.

G10915332

Courtesy of MAZDA MOTORS CORP.

⁽¹⁾	Because the combiner open/close angle cannot change if the tripmeter switch is pressed before the combiner fully closes, press the tripmeter switch after the combiner is fully closed.

If the display screen and open/close angle for the active driving display cannot be changed, refer to the symptom troubleshooting. (See SYMPTOM TROUBLESHOOTING [INSTRUMENT CLUSTER] .)