Leaving Home Light System

• There are three methods for personalizing the leaving home light system: Using the M-MDS, using the center display (with center display), and using the light switch.

Using M-MDS 

• CONTROL SYSTEM PERSONALIZATION FEATURES SETTING PROCEDURE

Using center display 

• CENTER DISPLAY PERSONALIZATION FEATURES SETTING PROCEDURE

Using dimmer switch 

1. Switch the ignition off.
   CAUTION:

   • Perform the procedure in Steps  2- 4 within 10 s.
2. Operate the dimmer switch to the passing position and wait for 3 s or more.
3. Operate the dimmer switch back to the LO position.
4. Operate the dimmer switch to the passing position and wait for 3 s.
5. Verify that the headlight high-beam indicator light flashes two times.

Courtesy of MAZDA MOTORS CORP.

• If the headlight high-beam indicator light does not flash two times, the procedure may have been performed incorrectly. Repeat the procedure from Step  2.