Coupling Component Calibration Data Writing
WARNING: This page is about a different variant/trim than selected.
- Connect the M-MDS to the DLC-2.
- After the vehicle is identified, select the following items from the toolbox of the M-MDS.
- Select "Chassis".
- Then, select items from the screen menu in the following order.
- Select "4WD/AWD".
- Select "Coupling Calibration Data Writing".
- Perform the configuration according to the directions on the screen.
- Verify all the DTCs for the control module connected to the CAN line.
- If any DTC is stored, clear it.
- If the DTC is cleared, finish the procedure because the configuration is completely normally.
- If the DTC remains, perform troubleshooting according to the DTC.