Function inspection

WARNING: This page is about a different variant/trim than selected.

Connect the M-MDS to the DLC-2.
Switch the ignition ON (engine off).
Display the PID ECT2 and ECT2_VOLT. (See PID/DATA MONITOR INSPECTION .)
Compare the voltage indications for PID ECT2_VOLT and the temperature indications for PID ECT2 with the standards in the table indicated below.
- If they do not match the standard, replace the PCM. (See PCM REMOVAL/INSTALLATION .)
- If they match the standard, perform the resistance inspection. (See RESISTANCE INSPECTION .)