Automatic Transaxle Removal/Installation: Notes

Special Service Tool (SST) 

Mazda SST number Global SST number
49 C017 5A0 - Engine support set	Courtesy of MAZDA MOTORS CORP.	49 UN30 3050 303-050 Engine lifting brackets	Courtesy of MAZDA MOTORS CORP.	49 L017 5A0 - Support hanger	Courtesy of MAZDA MOTORS CORP.
49 JP10 020 - Engine bracket	Courtesy of MAZDA MOTORS CORP.	-		-

CAUTION:

• If the automatic transaxle has been replaced, perform TCM configuration. (See TCM CONFIGURATION .)
• If the automatic transaxle has been replaced, perform initial learning. (See INITIAL LEARNING .)
• Performing the following procedures could cause an open circuit in the front ABS wheel-speed sensor wiring harness if it is pulled by mistake. Before servicing, disconnect the front ABS wheel-speed sensor and set it aside so that the wiring harness will not be pulled by mistake.
• Secure the steering wheel using tape or a cable to prevent the steering shaft from rotating after disconnecting the steering shaft. If the steering wheel rotates after the steering shaft and the steering gear and linkage are disconnected, the internal parts of the clock spring could be damaged.