Control Unit Configuration (Initial Setting) Procedure Using M-MDS: Reassembly

WARNING: This page is about a different car, the 2017 Mazda CX-5 and 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.

Standard values, such as torques and certain adjustments, must be strictly observed in the reassembly of all parts.

Fig 1: Caution For Assembling Parts
Courtesy of MAZDA MOTORS CORP.
If removed, the following parts should be replaced with new ones:
- Oil seals
- Gaskets
- O-rings
- Lock washers
- Cotter pins
- Nylon nuts
Depending on location:

Fig 2: Caution For Applying Sealant And Gasket
Courtesy of MAZDA MOTORS CORP.
- Sealant and gaskets, or both, should be applied to specified locations. When sealant is applied, parts should be installed before sealant hardens to prevent leakage.
- Oil should be applied to the moving components of parts.
- Specified oil or grease should be applied at the prescribed locations (such as oil seals) before reassembly.