Generator Internal Parts: Rotor

WARNING: This page is about a different car, the 2017 Mazda CX-9. However, it is still accessible from the selected car via links, so may be relevant.

Measure the resistance between the slip rings using a tester.

Fig 1: Measuring Resistance Between Slip Rings Using Tester
Courtesy of MAZDA MOTORS CORP.
- If not within specification, replace the rotor.
  Generator rotor resistance (between slip rings) [20 °C {68 °F}]
  
  1.8-2.1 ohms
Verify that there is no continuity between the slip ring and core using a tester.

Fig 2: Checking Continuity Between Slip Ring And Core Using Tester
Courtesy of MAZDA MOTORS CORP.
- If there is continuity, replace the rotor.
Inspect the slip ring surface condition.
- If the slip ring surface is rough, use a lathe or fine sandpaper to make it smooth.