Active Command Modes Table

NOTE:

Simulation items on parts which are not equipped to the vehicle do not operate.

SIMULATION PART DESCRIPTION

Simulation item	Unit/Operation	Data contents	Output part name	Operation condition
BG_HORN_RLY	Off/On	If an accessory part is installed, it cannot be used.
BLWR_RLY	Off/On	Off: Turns the blower relay off. On: Turns the blower relay on.	Blower relay	Ignition switched ON (engine off or on)
DR_LK_RY	Off/On	NOTE: The BCM sends a door lock relay operation request signal (lock signal) to the electrical supply unit (ESU) via LIN communication. Off: Does not lock the door. On: Locks the door.	Door lock relay	Ignition switched ON (engine off or on)
DR_UNLK_RY	Off/On	NOTE: The BCM sends a door unlock relay operation request signal (unlock signal) to the electrical supply unit (ESU) via LIN communication. Off: Does not unlock the door. On: Unlocks the door.	Door unlock relay	Ignition switched ON (engine off or on)
F_FOG_RELAY	Off/On	NOTE: Displayed on M-MDS but does not function.
H/L_CLN_RY	Off/On	NOTE: Displayed on M-MDS but does not function.
H/L_DRL	Off/On	NOTE: The BCM sends a running light on request signal to the electrical supply unit (ESU) via LIN communication. Off: The running lights are turned off. On: The running lights are turned on.	Running light	Ignition switched ON (engine off or on)
H/L_HI	0%/100%	NOTE: The BCM sends a headlight HI on request signal to the electrical supply unit (ESU) via LIN communication. 0%: The headlights HI are turned off. 100%: The headlights HI are turned on.	Headlight HI	Ignition switched ON (engine off or on)
H/L_LOW	0%/100%	NOTE: The BCM sends a headlight LO on request signal to the electrical supply unit (ESU) via LIN communication. 0%: The headlights LO are turned off. 100%: The headlights LO are turned on.	Headlight LO	Ignition switched ON (engine off or on)
H/L_TNS	Off/Right-On/Left-On/On	NOTE: The BCM sends a TNS (parking lights) on request signal to the electrical supply unit (ESU) via LIN communication. Off: Turns the parking lights off. Right-On: Turns the parking light (RH) on. Left-On: Turns the parking light (LH) on. On: Turns the parking lights (RH/LH) on.	Parking light	Ignition switched ON (engine off or on)
HORN_RLY	Off/On	Off: Stops the horn. On: Sounds the horn.	Horn relay	Ignition switched ON (engine off or on)
PTC_HEAT_ST	0%/10%/20%/30%/40%/50%/60%/70%/80%	NOTE: Displayed on M-MDS but does not function.
R_DEF_RLY	Off/On	Off: Stops the rear window defogger. On: Operates the rear window defogger.	Rear window defogger relay	Ignition switched ON (engine off or on)
R_FOG_LAMP	Off/On	NOTE: Displayed on M-MDS but does not function.
REVERSE_LMP	Off/On	NOTE: The BCM sends a back-up light on request signal to the electrical supply unit (ESU) via LIN communication. Off: Turns the back-up light off. On: Turns the back-up light on.	Back-up light	Ignition switched ON (engine off or on)
ROOM_LAMP	Off/100%_On	NOTE: The BCM sends a map light on request signal to the electrical supply unit (ESU) via LIN communication. Off: Turns the map light off. 100%_On: Turn the map light on.	Map light	Ignition switched ON (engine off or on)
STOP_LMP_CTL	Off/On	NOTE: Displayed on M-MDS but does not function.
TRUNK_LAMP	Off/On	NOTE: The BCM sends a trunk compartment light on request signal to the electrical supply unit (ESU) via LIN communication. Off: Turns the trunk compartment light off. On: Turns the trunk compartment light on.	trunk compartment light	Ignition switched ON (engine off or on)
TRUNK_MOTOR	Off/On	NOTE: The BCM sends a trunk lid release signal to the electrical supply unit (ESU) via LIN communication. Off: Does not open the trunk. On: Opens the trunk.	Trunk lid release relay	Ignition switched ON (engine off or on)
WASHER_CTRL	Off/Front_ON	NOTE: The BCM sends a washer operation request signal to the electrical supply unit (ESU) via LIN communication. Off: Stops the washer motor. Front_ON: Operates the washer motor.	Washer motor	Ignition switched ON (engine off or on)
WIP_R_CTRL	Off/INT/On/On_1Time/On_2Time/On_3Time/On_4Time	NOTE: Displayed on M-MDS but does not function.