Center Accessory Socket Inspection

1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION ).
2. Remove the following parts:
   1. Console side panel (See CONSOLE SIDE PANEL REMOVAL/INSTALLATION ).
   2. Switch panel (See SWITCH PANEL REMOVAL/INSTALLATION ).
   3. Cup holder (See CUP HOLDER REMOVAL/INSTALLATION ).
   4. Selector lever knob (See SELECTOR LEVER COMPONENT REMOVAL/INSTALLATION ).
   5. Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION ).
   6. Front console box (See FRONT CONSOLE BOX REMOVAL/INSTALLATION ).
   7. Side wall (See SIDE WALL REMOVAL/INSTALLATION ).
   8. Rear console (See REAR CONSOLE REMOVAL/INSTALLATION ).
   9. Center accessory socket (See CENTER ACCESSORY SOCKET REMOVAL/INSTALLATION ).
3. Connect the tester probe to the position shown in the figure and verify that there is continuity.

Courtesy of MAZDA MOTORS CORP.

• If it cannot be verified, replace the center accessory socket. (See CENTER ACCESSORY SOCKET REMOVAL/INSTALLATION ).