Function Inspection Using M-MDS

P0011-00: (PCM (SKYACTIV-G)) DIAGNOSTIC PROCEDURE

Step	Inspection	Results	Action
1	PURPOSE: VERIFY RELATED REPAIR INFORMATION OR SERVICE INFORMATION AVAILABILITY Verify related Service Bulletins, on-line repair information, or Service Information availability. Is any related Information available?	Yes	Perform repair or diagnosis according to the available information. If the vehicle is not repaired, go to the next step.
1		No	Go to the next step.
2	PURPOSE: RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION Record the freeze frame data/snapshot data. NOTE: Recording can be facilitated using the screen capture function of the PC.	-	Go to the next step.
3	PURPOSE: INSPECT FOR OTHER RELATED DTC Perform the DTC inspection for the PCM. (See DTC INSPECTION .) Are any of the following DTCs displayed? P0010-00: P0335-00: P0340-00: P1380-00:	Yes	Repair or replace the malfunctioning location according to the applicable DTC troubleshooting. (See P0010-00: [PCM (SKYACTIV-G)] .) (See P0335-00: [PCM (SKYACTIV-G)] .) (See P0340-00: [PCM (SKYACTIV-G)] .) (See P1380-00: [PCM (SKYACTIV-G)] .) Go to the next step.
3		No	Go to the next step.
4	PURPOSE: VERIFY CONFORMITY OF ACTUAL INTAKE VALVE TIMING Start the engine and idle it. Access the following PIDs using the M-MDS: (See PID/DATA MONITOR INSPECTION .) VLV_TIMING_ACT_IN VLV_TIMING_DSD_IN Perform the following: Race the engine at an engine speed of 3, 000 rpm or less. Idle the engine. Repeat Step 1 and 2 operations above five times in succession. Does the monitor value of the PID item [VLV_TIMING_ACT_IN] conform to the [VLV_TIMING_DSD_IN] PID value?	Yes	Go to the next step.
4		No	Vehicles with i-ELOOP: Go to Troubleshooting Diagnostic Procedure to perform the procedure from Step 1. Vehicles without i-ELOOP: Go to Troubleshooting Diagnostic Procedure to perform the procedure from Step 3.
5	PURPOSE: VERIFY CONNECTOR CONNECTIONS Start the engine. Access the PCM PID [VLV_TIMING_ACT_IN] using the M-MDS. (See PID/DATA MONITOR INSPECTION .) Does the PID value fluctuate when the following connectors are shaken? Electric variable valve timing motor/driver PCM	Yes	Repair or replace the applicable wiring harness or connector parts. Go to Troubleshooting Diagnostic Procedure to perform the repair completion verification 1.
5		No	Vehicles with i-ELOOP: Go to Troubleshooting Diagnostic Procedure to perform the procedure from Step 1. Vehicles without i-ELOOP: Go to Troubleshooting Diagnostic Procedure to perform the procedure from Step 3.