Function Inspection Using M-MDS

P0116-00: (PCM (SKYACTIV-G)) DIAGNOSTIC PROCEDURE

Step	Inspection	Results	Action
1	PURPOSE: VERIFY RELATED REPAIR INFORMATION OR SERVICE INFORMATION AVAILABILITY Verify related Service Bulletins, on-line repair information, or Service Information availability. Is any related Information available?	Yes	Perform repair or diagnosis according to the available information. If the vehicle is not repaired, go to the next step.
1		No	Go to the next step.
2	PURPOSE: RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION Record the freeze frame data/snapshot data. NOTE: Recording can be facilitated using the screen capture function of the PC.	-	Go to the next step.
3	PURPOSE: VERIFY CONNECTOR CONNECTIONS Start the engine. Access the PCM PID [ECT] using the M-MDS. (See PID/DATA MONITOR INSPECTION .) Does the PID value fluctuate when the following connectors are shaken? ECT sensor PCM	Yes	Repair or replace the applicable connector parts. Go to Troubleshooting Diagnostic Procedure to perform the repair completion verification 1.
3		No	Go to the next step.
4	PURPOSE: VERIFY ECT SENSOR INPUT SIGNAL Access the PCM PID [ECT] using the M-MDS. (See PID/DATA MONITOR INSPECTION .) Is the monitor value normal?	Yes	Go to Troubleshooting Diagnostic Procedure to perform the procedure from Step 3.
4		No	Go to Troubleshooting Diagnostic Procedure to perform the procedure from Step 1.