Shock Absorber: Installation
- To install, reverse removal procedure and note the following: Install bottom rubber bushing onto top of special shock absorber before installing into vehicle.
- Plugged hole in shock absorber must point toward frame crossmember and mounting pin must protrude through bore in frame crossmember.
- Make sure all bolts and fittings are tight and reservoir is full; then fill leveling valve by starting engine and moving leveling lever up to filling position. Check leveling suspension system for proper operation.
TIGHTENING SPECIFICATIONS
| Application | Ft. Lbs. (mkg) | |
|---|---|---|
| Upper Mount Bolt | 22 (3.0) | |
| Lower Mount Bolt | 33 (4.6) | |
| Pressure Hose-to-Shock | ||
| Absorber Fitting | 15 (2.0) | |
| Pressure Hose-to-Fitting | 15 (2.0) | |
| Spherical Mount on Shock Absorber | 48 (6.6) | |
| Fitting at Pressure Reservoir | 32 (4.4) | |