FixVault

Component/Circuit Identification

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2000 Mercedes-Benz ML320, 2000 Mercedes-Benz E320, 2000 Mercedes-Benz CLK320, 2000 Mercedes-Benz C280, and 1999 Mercedes-Benz ML320. However, it is still accessible from the selected car via links, so may be relevant.

System components and connections are identified by the manufacturer with special designations in diagnostic information. See COMPONENT/CIRCUIT IDENTIFICATION  table.

COMPONENT/CIRCUIT IDENTIFICATION

Component/Circuit Manufacturer's Designation
Air Pump Relay Module K40/4k3x
Air Pump Switchover Valve Y32
Backup Light Switch S16/2
Drive Authorization System (DAS) Control Module N54/1
Camshaft (CMP) Sensor B6/1
CAN BUS From ESP/SPS Control Module N47-5
Clutch Engage/Release Switch S40/2
Crankshaft Position (CKP) Sensor L5
Cruise Control Switch S40
EA/CC/ISC Actuator M16/6
EGR Switchover Valve Y27
EGR Valve Vacuum Transducer Y31/1
Engine Control Module (ECM) N3/10
Engine/Climate Control Electric Cooling Fan Control Module M4/3
Engine Coolant Temperature (ECT) Sensor B11/4
ECM Tachometer Signal TN Signal
EVAP Charcoal Canister Shut-Off Valve Y58/4
Fuel Injector (1) Y62y1
Fuel Tank Pressure Sensor B4/3
Fuse/Relay Panel F1
Ignition Coil (2) T1/1
Ignition/Starter Switch S2/1
Knock Sensor 1 (Right) A16g1
Knock Sensor 2 (Left) A16g2
Mass Airflow Sensor (MAF) B2/5
Oil Sensor B40
Output Ground Circuit (Models 202, 208 & 210) W16/6
Ground Circuit (Model 163) W16
O2S 1 Left (Before TWC) G3/3
O2S 1 Right (Before TWC) G3/4
O2S 2 Left (After TWC) G3/5
O2S 2 Right (After TWC) G3/6
Passenger Side Fuse/Relay Panel K40/4
Pedal Value Sensor B37
Pressure Sensor B28
Purge Control Valve Y58/1
Relay Module K40
Resonance Intake Manifold Switchover Valve Y22/6
Starter Relay Module (Models 202, 208 & 210) K40/4k2
Starter Relay Module (Model 163) F1k8
Starter Signal Circuit Circuit 50
Stop Light Switch S9/1
Transmission Control Module N15/3
Voltage Supply Circuit Circuit 30
(1) Last number identifies injector number.
(2) Last number identifies coil number.