Mixture Formation -- E350 (211.256)

• General Information
  • Use of unleaded fuels (premium and regular) - AH07.00-P-1000-01A
  • Use of unleaded fuels, Super Plus - AH07.00-P-1000-04A
  • References to test conditions for engine testing and adjusting work - AH07.00-P-3000-01A
  • General notes: Passenger cars: Mixture formation - AH07.00-Z-9999AZ
  • ME-SFI vehicle features - AH07.61-P-0002-02VU
• Testing & Repair
  • General - AR07.00-P-1000-01A
  • Exhaust emission test I - AR07.00-P-1000A
  • Testing and repair work: Passenger cars: Mixture formation - AR07.00-Z-9000AB
  • Testing and repair work: Passenger cars: Mixture formation - AR07.00-Z-9272AB
  • Remove/install fuel distributor with injection valves (ME-SFI) - AR07.03-P-1451TS
  • Reduce fuel pressure through service valve - AR07.03-P-1460-01VA
  • Remove/install injection valves (ME-SFI) - AR07.03-P-6520TS
  • Remove/install radiator identification sensor - AR07.04-P-5004GZH
  • Remove/install hot film mass air flow sensor - AR07.07-P-1453TS
  • Remove/install injection system control unit - AR07.08-P-7008TS
  • Remove/install throttle valve actuator - AR07.51-P-1401TS
  • Remove/install heated O2 sensor - AR07.52-P-5303TS
  • Testing and repair work: Passenger cars: Electrical drive system - AR08.00-Z-9272AB
• Safety Precautions
  • Safety information: Mixture formation - AS07.00-Z-9999ZZ
  • Risk of explosion caused by ignition or explosion of fuel. Risk of injury to skin and eyes caused by fuel jets or leakage. - AS07.70-Z-0001-01A
• Torque Specifications
  • Tightening torques: Passenger cars: Mixture formation - BA07.00-Z-9999AZ
  • Injection nozzles, injection valves, lines - BA07.03-P-1000-01B
  • Control unit - BA07.08-P-1000-01A
  • ME gasoline injection and ignition system - BA07.61-P-1000-01D
  • Tightening torques: Passenger cars: Electrical drive system - BA08.00-Z-9999AZ
• Test & Adjustment Values
  • Test and adjustment values: Passenger cars: Mixture formation - BE07.00-Z-9999AZ
• Basic Knowledge
  • Component description for fuel injection valves - GF07.03-P-6010V
  • Knock sensor component description - GF07.04-P-6030V
  • Coolant temperature sensor component description - GF07.04-P-6040V
  • Pressure sensor component description - GF07.04-P-6060V
  • O2 sensors, component description - GF07.04-P-6100V
  • O2 sensors, component description - GF07.04-P-6100VA
  • Component description for the crankshaft Hall sensor - GF07.04-P-6220V
  • Component description for the position sensor tumble flap - GF07.04-P-6230V
  • Component description for the intake manifold tumble flap switchover valve - GF07.05-P-6030V
  • Hot film MAF sensor, component description - GF07.07-P-6000V
  • Self-adjustment of mixture formation, function - GF07.10-P-1029V
  • Smooth engine running analysis, function - GF07.10-P-1030V
  • Motor Electronics (ME-SFI) for fuel injection and ignition system arrangement of components - GF07.61-P-0001-01VA
  • Motor Electronics (ME-SFI) for fuel injection and ignition system arrangement of components - GF07.61-P-0001-01VC
  • Motor electronics (ME-SFI) fuel injection and ignition system function diagram - GF07.61-P-0001-02V
  • Motor electronics (ME) fuel injection and ignition system control unit, input signals - GF07.61-P-0001-06V
  • Motor electronics (ME) fuel injection and ignition system control unit, output signals - GF07.61-P-0001-07V
  • Motor electronics (ME-SFI) fuel injection and ignition system, model and major assembly installation survey - GF07.61-P-0001-12V
  • Table of contents for function description of motor electronics (ME-SFI) fuel injection and ignition system - GF07.61-P-0999V
  • ME-SFI starting, function - GF07.61-P-2003V
  • Diagnosis fault memory, ME-SFI function - GF07.61-P-2004V
  • ME-SFI driving mode, function - GF07.61-P-2005V
  • ME-SFI idle, function - GF07.61-P-2006V
  • ME alternator interface function - GF07.61-P-3003V
  • ME fuel supply, function - GF07.61-P-3004V
  • ME-SFI ignition ON, function - GF07.61-P-3005V
  • The ME limiting maximum vehicle speed function - GF07.61-P-3007V
  • The ME-SFI start quantity control function - GF07.61-P-3010V
  • The ME-SFI post-start enrichment function - GF07.61-P-3011V
  • ME-SFI fuel pump actuation, function - GF07.61-P-3012V
  • Purge control valve actuation, function - GF07.61-P-3013V
  • ME-SFI acceleration enrichment, function - GF07.61-P-3015V
  • ME-SFI part load/full load operation, function - GF07.61-P-3016V
  • ME engine speed signal, function - GF07.61-P-3017V
  • The ME-SFI safety fuel shutoff function - GF07.61-P-3018V
  • The ME-SFI limiting maximum vehicle speed function - GF07.61-P-3019V
  • ME-SFI two-sensor control, function - GF07.61-P-3020V
  • ME-SFI warming-up control, function - GF07.61-P-3022V
  • The fan control function - GF07.61-P-3023V
  • O2 sensor heater function - GF07.61-P-3025V
  • Intake manifold switchover, function - GF07.61-P-3028V
  • The correction programming function - GF07.61-P-3031V
  • ME-SFI TWC heating-up, function - GF07.61-P-3032V
  • ME-SFI synchronization of fuel injection and firing order, function - GF07.61-P-4009V
  • ME engine torque requirements function - GF07.61-P-4015V
  • ME engine coolant heat management function - GF07.61-P-4016VB
  • ME tumble flap switchover function - GF07.61-P-4017V
  • ME power steering pump pressure regulator valve actuation function - GF07.61-P-4018V
  • ME-SFI deceleration fuel shutoff, function - GF07.61-P-4019V
  • Camshaft adjustment, function - GF07.61-P-4021V
  • ME-SFI lambda control, function - GF07.61-P-4022V
  • ME-SFI transmission shift delay, function - GF07.61-P-4023V
  • ME fuel reserve signal, function - GF07.61-P-4024V
  • Transmission overload protection, function - GF07.61-P-4026V
  • Overheating/pinging protection, function - GF07.61-P-4027V
  • Voltage supply of ME-SFI control unit, function - GF07.61-P-5001V
  • ME-SFI [ME] control unit, component description - GF07.61-P-6000V
  • Component description of fuel distribution rail - GF07.61-P-6020V
  • Motor electronics (ME-SFI) fuel injection and ignition system - survey of system components, location/task/design/function - GF07.61-P-9999V
• Special Tools
  • 000 589 68 03 00 Box wrench bit - WS07.00-N-0004A
  • 000 589 00 68 00 Cleaning kit - WS07.00-P-0001C
  • 000 589 68 03 00 Box wrench bit - WS07.00-P-0004B
  • 103 589 00 21 01 Pressure gauge - WS07.00-P-0014-01B
  • 103 589 00 21 04 Pressure hose - WS07.00-P-0014-02B
  • 103 589 00 21 05 Pressure hose - WS07.00-P-0014-03B
  • 103 589 00 21 00 Testing unit - WS07.00-P-0014B
  • 119 589 04 63 00 Pressure hose - WS07.00-P-0024B
  • 000 589 69 03 00 Ring wrench bit - WS07.00-P-0088B
  • 272 589 02 63 00 4-pin adapter cable - WS07.00-P-0105B
  • 266 589 01 63 00 154-pin adapter cable - WS07.00-P-0121B
  • Special tools: Passenger cars: Mixture formation - WS07.00-Z-9999AZ
  • Special tools: Passenger cars: Electrical drive system - WS08.00-Z-9999AZ