FixVault

Ignition OFF, function - GF07.10-P-1002MMC

ENGINES 157.9 in MODEL 216.3, 221.0/1 

ENGINES 278.9 in MODEL 216.3, 221.0/1 

Function requirements ignition OFF, general points 

Ignition OFF, general points 

For ignition OFF, first the engine and then the engine control is switched off in the ME-SFI [ME] control unit (N3/10).

Function sequence for ignition OFF 

When ignition is switched OFF the circuit 15 (2) relay/reserve 1 (changeover contact) (N10/1kD) is switched off by the EZS control unit (N73) via the interior CAN (CAN B) and by the front SAM control unit with fuse and relay module (N10/1). The signal "circuit 15 OFF" is sent redundantly via the chassis CAN (CAN E) to the ME-SFI [ME] control unit.

If the ME-SFI [ME] control unit receives the "circuit 15 OFF" signal via the circuit 15 relay the engine is switched off by shutting off the fuel pump (M3), the fuel injectors (Y76) and the ignition coils (T1) are switched off and the computer power-down is started.

Computer power-down is determined by the ME-SFI [ME] control unit and lasts about 4 s. It can, however, last for some minutes due to various functions (such as On-Board Diagnosis (OBD), Drive Authorization System (DAS), thermal management).

When computer power-down is complete, the engine circuit 87 relay (N10/1kC) is de-energized and the engine control is disconnected from the on-board electrical system (switched off).

IMPORTANT

System tests are conducted by the ME-SFI [ME] control unit during the computer power-down and the fault memory is updated.

The "circuit 31" ground connection takes place from the on-board electrical system battery (G1) via the battery ground (W10) and over a number of ground lines to the electronic ground (footwell on the left) (W34/1).

When the ignition is OFF, the ME-SFI [ME] control unit is supplied with power from the on-board electrical system battery via "circuit 30 fused".

REFER TO SYSTEM WIRING DIAGRAMS Electrical function diagram for ignition OFF Model 216 PE07.10-P-2702-97CAH
Model 221 PE07.10-P-2702-97SAG
  Overview of system components for gasoline injection and ignition system with direct injection   GF07.70-P-9998MMB