FixVault
Home › Mercedes Benz › 2025 › Sprinter 3500 Van Cargo Extended › Repair and Diagnosis › External Pages › Different car › Section 3190 (Electronic Control Modules (Service Information)) › Module, Power Liftgate Control (PLGM) › Removal And Installation › Removal And Installation › Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2020 Chrysler Voyager and 2020 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Position the right rear quarter trim panel aside in the rear enough to gain access to the module. Refer to PANEL, QUARTER TRIM, REMOVAL AND INSTALLATION .
    GC0178017Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the wire harness connectors (2) from the Power LiftGate Module (PLGM) (1).
    GC0177899Courtesy of CHRYSLER GROUP, LLC
  4. Depress the alignment mounting tab (1) and lift up on the that section of the module and pull slightly aft to disengage the rear alignment mounting tabs (2).
  5. Remove the PLGM from the vehicle.
About FixVault