Throttle Position (TP) Switch (FESTIVA)

Ensure idle speed and ignition timing are adjusted to specification. Stop engine. Disconnect negative battery cable.
CAUTION: DO NOT tamper with throttle stop screw at throttle lever. Doing so may result in damage to throttle body.
Unplug TP switch connector at throttle body. Insert appropriate feeler gauge between throttle stop screw and stop lever. Check for continuity between specified terminals on TP switch connector. See ADJUSTMENTS article in the ENGINE PERFORMANCE Section and THROTTLE POSITION SWITCH CONTINUITY table.

THROTTLE POSITION SWITCH CONTINUITY

Test Condition ⁽¹⁾

⁽²⁾⁽³⁾ Continuity Between IDL-TL

⁽²⁾⁽⁴⁾ Continuity Between PSW-TL

.02" (.5 mm)

Yes

.03" (.7 mm)

Wide Open Throttle

Yes

⁽¹⁾	Insert specified feeler gauge between throttle adjustment screw and stop lever.

⁽²⁾	Throttle position sensor connector terminals.

⁽³⁾	Yellow/Black and Black wires on mating connector.

⁽⁴⁾	Yellow and Black wires on mating connector