Wiper/Washer Switch Test
Remove lower steering column cover to gain access to wiper switch connector. Using an ohmmeter, ensure continuity exists between terminals listed in table at specified switch positions. See WIPER/WASHER SWITCH CONTINUITY table. See Fig 1 . If switch does not test as specified, replace wiper/washer switch.
WIPER/WASHER SWITCH CONTINUITY
| Terminal | Position | Continuity | ||
|---|---|---|---|---|
| BLU - BLU/ORG | Pull Washer Lever | Yes | ||
| BLU/ORG - BLU | Release Washer Lever | No | ||
| BLU - BRN/WHT | Intermittent | Yes | ||
| BLU - BRN/WHT | All Other Positions | No | ||
| BLU - GRN | Low | Yes | ||
| BLU - GRN | High | Yes | ||
| BLU - GRN | All Other Positions | No | ||
| BLU - BLU/RED | High | Yes | ||
| BLU - BLU/RED | All Other Positions | No | ||
| ORG - YEL/RED | Rotate INT Control Knob | (1) | ||
|
||||