Inspection and Verification
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Verify the customer concern.
- Visually inspect for obvious signs of mechanical or electrical damage.VISUAL INSPECTION TABLE
Mechanical Electrical - Headlamp assembly
- Smart Junction Box (SJB) fuse 42 (10A)
- Wiring, terminals or connectors
- Headlamp Control Module (HCM)
- If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
- If the cause is not visually evident, connect the scan tool to the Data Link Connector (DLC).
- If the scan tool does not communicate with the VCM:
- Check the VCM connection to the vehicle.
- Check the scan tool connection to the VCM.
- Refer to MODULE COMMUNICATIONS NETWORK -- FUSION, MILAN & MKZ article, No Power To The Scan Tool, to diagnose no power to the scan tool.
- If the scan tool does not communicate with the vehicle:
- Verify the ignition key is in the ON position.
- Verify the scan tool operation with a known good vehicle.
- Refer to MODULE COMMUNICATIONS NETWORK -- FUSION, MILAN & MKZ article to diagnose no response from the PCM.
- Carry out the network test.
- If the scan tool responds with no communication for one or more modules, refer to MODULE COMMUNICATIONS NETWORK -- FUSION, MILAN & MKZ article.
- If the network test passes, retrieve and record the continuous memory DTCs.
- Clear the continuous DTCs and carry out the self-test diagnostics for the HCM.
- If the DTCs retrieved are related to the concern, go to DIAGNOSTIC TROUBLE CODE (DTC) TABLE in this service information. For all other DTCs, refer to the Diagnostic Trouble Code (DTC) Table in MULTIFUNCTION ELECTRONIC MODULES -- FUSION, MILAN & MKZ article.
- If no DTCs related to the concern are retrieved, GO to SYMPTOM TABLE .
NOTE:
Make sure to use the latest scan tool software release.
NOTE:
The Vehicle Communication Module (VCM) LED prove-out confirms power and ground from the DLC are provided to the VCM.