FixVault
Home › Mercury › 2002 › Villager Base › Repair and Diagnosis › External Pages › Different car › Section 587 (Acceleration Control System) › Removal And Installation › Accelerator Pedal and Bracket › Removal

Accelerator Pedal and Bracket: Removal

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

  1. Disconnect the battery ground cable. For additional information, refer to BATTERY CABLES .
  2. Disconnect the accelerator pedal sensor electrical connector.
    3. NOTE: This electrical connector is present on all vehicles including fixed pedal and bracket assemblies. The electrical connector on the fixed pedal assemblies are non-working and plugged into an empty receptacle connector.
  3. Disconnect the accelerator pedal motor electrical connector.

    4. Vehicles with adjustable accelerator pedal and bracket 

  4. Disconnect the accelerator pedal motor drive cable connector.

    5. All vehicles 

  5. Remove the 3 accelerator pedal and bracket retainer nuts.
  6. Remove the accelerator pedal and bracket assembly.
About FixVault