FixVault
Home › Mercury › 2005 › Grand Marquis LS › Repair and Diagnosis › Engine Performance › Remove, Overhaul & Install › Electronic Engine Control System › Removal And Installation › Throttle Position (TP) Sensor › Removal

Throttle Position (TP) Sensor: Removal

  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the throttle position (TP) sensor electrical connector.
    3. CAUTION: Failure to remove the TP sensor screws in the following manner will result in damage to the screws. First loosen the screws 1-2 full turns using a hand tool and then use a suitable high-speed driver to complete the removal.
  3. Remove and discard the 2 screws and the TP sensor.
About FixVault