FixVault
Home › Mercury › 2005 › Monterey › Repair and Diagnosis › Engine Performance › Remove, Overhaul & Install › Electronic Engine Control System › Removal And Installation › Mass Air Flow (MAF) Sensor › Removal and Installation

Removal and Installation

  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the MAF sensor electrical connector.
  3. Remove the 2 MAF sensor screws and the MAF sensor.
    • To install, tighten to 10 Nm (89 lb-in).
  4. To install, reverse the removal procedure.
About FixVault