FixVault
Home › Mercury › 2006 › Montego Base, AWD › Repair and Diagnosis › Engine Performance › Remove, Overhaul & Install › Electronic Engine Control System › Removal And Installation › Knock Sensor (KS) › Removal and Installation

Removal and Installation

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the battery ground cable. For additional information, refer to REMOVAL AND INSTALLATION .
  3. Position the knock sensor (KS) heat shield aside.
    Fig 1: Locating Knock Sensor
    G03990667Courtesy of FORD MOTOR CO.
  4. Disconnect the KS electrical connector.
  5. Remove the bolt and the KS.
    • To install, tighten to 20 Nm (15 lb-ft).
  6. To install, reverse the removal procedure.
About FixVault