FixVault
Home › Mercury › 2006 › Montego Base, AWD › Repair and Diagnosis › Engine Performance › Remove, Overhaul & Install › Electronic Engine Control System › Removal And Installation › Mass Air Flow (MAF) Sensor › Removal and Installation

Removal and Installation

  1. Disconnect the battery ground cable. For additional information, refer to REMOVAL AND INSTALLATION .
  2. Disconnect the mass air flow (MAF) sensor electrical connector.
  3. Remove the 2 screws and the MAF sensor.
    • To install, tighten to 2 N.m (18 lb-in).
  4. To install, reverse the removal procedure.
About FixVault