FixVault
Home › Mercury › 2006 › Montego Base, AWD › Repair and Diagnosis › External Pages › Different car › Section 249 (Engine System-General Information) › General Procedures › Exhaust Manifold Cleaning and Inspection

Exhaust Manifold Cleaning and Inspection

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
SPECIAL TOOL SPECIFICATIONS

G04583403
 Straight Edge
303-D039 (D83L-4201-A) or equivalent
  1. Clean the exhaust manifold using a suitable solvent. Use a plastic scraping tool to clean the gasket sealing surfaces.
    2. NOTE: New exhaust manifold gaskets, studs, nuts and/or bolts must be installed when an exhaust manifold is serviced.
    Fig 1: Checking Exhaust Manifold Sealing Surface For Warpage
    G03913726Courtesy of FORD MOTOR CO.
  2. Using the special tool (or a precision straight edge) and a feeler gauge, check the exhaust manifold sealing surface for warpage. If the warpage is greater than 0.76 mm (0.0299 in), install a new exhaust manifold.
About FixVault