FixVault
Home › Mercury › 2006 › Montego Base, AWD › Repair and Diagnosis › Suspension › Wheel Alignment › Suspension System-General Information › General Procedures › Toe Adjustment - Front

Toe Adjustment - Front

  1. Using alignment equipment and the manufacturer's instructions, measure the front toe.
  2. Start the engine and center the steering wheel.
  3. Turn the engine OFF and, using a suitable steering wheel holding device, lock the steering wheel in the straight-ahead position.
  4. Remove the steering gear bellows clamps.
    Fig 1: Removing Steering Gear Bellows Clamps
    G04655258Courtesy of FORD MOTOR CO.
  5. Loosen the nuts.
    Fig 2: Loosening Nuts
    G04655259Courtesy of FORD MOTOR CO.
    6. NOTE: Do not allow the steering gear bellows to twist when the tie rod is rotated.
  6. Rotate the tie rods as necessary to adjust the toe setting.
  7. Tighten the nuts to 80 N.m (59 lb-ft).
    Fig 3: Tightening Nuts
    G04655260Courtesy of FORD MOTOR CO.
  8. Install the steering gear bellows clamps.
  9. Recheck the toe settings and adjust as necessary.
About FixVault