Seat - Front: Installation

CAUTION: Inspect the side impact protection system (SIPS) in the area of seat mounting for damage and distortion before installing the seat(s). Failure to follow this instruction may result in the seat fasteners not being correctly installed. Refer to BODY REPAIRS article, (side impact reinforcement) for additional removal and installation SIPS information.

All seats

Position the seat in the vehicle.
Connect the seat electrical connector(s).

Seat with memory

Connect the memory seat electrical connector.
- Make sure the lever is all the way back and in the fully released position.
- Align the connector uniformly and lightly push in until a subtle audible click is heard and slight resistance is felt.
- Using the lever, pivot it toward the seat connector end, drawing the connector into its mating end.
- Make sure the locking tab is engaged to the retainer on the lever.

Fig 1: Driver Seat Memory Electrical Connector

Courtesy of FORD MOTOR CO.

All seats

Position the seat track on the SIPS bar and install the 2 seat rear mounting bolts.
- Align the seat track rear locators into the SIPS.
- Tighten to 48 Nm (35 lb-ft).
Install the 2 seat-to-floor bolts.
- Tighten to 48 Nm (35 lb-ft).
Install the 2 seat-to-floor bolt covers.
Position the safety belt anchor (driver seat) or safety belt anchor with BTS (passenger seat) onto the stud and install the nut.
- Tighten to 35 Nm (26 lb-ft).
- If passenger seat, connect the BTS electrical connector.
Install the seat cushion side shield cover.
- Make sure the safety belts and buckles are accessible to the occupants after installation.
- Verify the safety belt retractor operates without excessive effort or binding.
Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of SUPPLEMENTAL RESTRAINT SYSTEM article.