FixVault
Home › Mercury › 2008 › Sable Base, AWD › Repair and Diagnosis › Electrical › Gauges › Instrument Panel And Console › Removal And Installation › Power Point › Removal

Power Point: Removal

NOTE: Power point cover may differ depending on location.
  1. Open the power point cover.
  2. Install the Power Point Socket Remover in one of the power point socket slots.
    3. Fig 1: Installing Special Tool In Power Point Socket Slot
    GF0038824Courtesy of FORD MOTOR CO.
  3. Position the Power Point Socket Remover so that it engages in the adjacent slot.
    4. Fig 2: Positioning Special Tool To Engage In Adjacent Slot
    GF0038825Courtesy of FORD MOTOR CO.
  4. Using the Power Point Socket Remover, pull the power point socket out of the retainer.
    5. Fig 3: Pulling Power Point Socket Out Of Retainer
    GF0038826Courtesy of FORD MOTOR CO.
  5. Disconnect the electrical connector.
About FixVault