Lumbar Assembly: Installation

All vehicles 

1. Slide the lumbar support bracket and lumbar assembly on the lumbar seat frame until seated on the 2 clips.
Fig 1: Lumbar Support Bracket Clips
Courtesy of FORD MOTOR CO.
2. Connect the electrical connector.
Fig 2: Lumbar Motor Electrical Connector
Courtesy of FORD MOTOR CO.
3. Install the lumbar motor and attach the lumbar motor bracket clip.
Fig 3: Lumbar Motor Bracket Clip
Courtesy of FORD MOTOR CO.
4. Attach the cushion trim cover rear corner J-clip.
5. Attach the cushion trim cover rear J-clip.
Fig 4: Identifying Cushion Trim Cover Rear J-Clip
Courtesy of FORD MOTOR CO.

Non-police vehicles 

NOTE: Note the alignment of the 2 side J-clips at the top of the seat to avoid bunching.
6. Attach the backrest trim cover J-clips.
   • Attach the 2 side J-clips first and then attach the lower J-clip.
Fig 5: Backrest Trim Cover J-Clips
Courtesy of FORD MOTOR CO.

Police vehicles 

NOTE: Inspect the seat backrest trim panel retaining hooks for damage. If damaged, install a new seat backrest trim panel.
7. Install the backrest trim panel.
   1. Angle the top of the seat backrest trim panel inward and down to engage the 2 upper retaining hooks to the backrest frame.
   2. Push in on the lower backrest trim panel and install the 2 screws.
Fig 6: Backrest Trim Panel & Screws
Courtesy of FORD MOTOR CO.
8. Pull the seat backrest material down, zip both zippers and tuck the zippers under the material.
Fig 7: Identifying Zippers
Courtesy of FORD MOTOR CO.