Air Spring: Installation

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.

Install the air spring in the following sequence.
1. Position the air spring assembly in the frame seat.
2. Install the spring retainer clip.
Seat the bottom of the air spring on the rear axle.

Fig 1: Air Spring On Rear Axle

Courtesy of FORD MOTOR CO.

NOTE: When installing the air tubes, make sure the white tube is fully inserted into the fitting for correct installation.

Connect the air spring solenoid valve in the following sequence.
1. Connect the air spring solenoid electrical connector.
2. Connect the air tube.
3. Make sure the air spring is in the correct shape.

NOTE: To avoid damage to the air spring, do not allow the suspension to compress before the spring is inflated.

Lower the vehicle until the wheel and tire assemblies are slightly above the ground.
Using the scan tool, inflate the air springs.